Page 1 of 1

Restricting Output During A Sync

PostPosted: Sat Mar 03, 2007 8:22 pm
by gaming_mouse
I am running the sync service from the command line (though this question applies equally for the gui), and the output of a typical sync is full of information (like the output below) that I am not interested in at all. The only output I want to see is the names of the out of date files being transferred. Is there a way to restrict the output to something like that?

Current irrelevant output sample:

Code: Select all
COMMAND-0:>     pwd
        257 "/extra/config" is current directory.
COMMAND-0:>     TYPE A
        200 Type set to A
COMMAND-0:>     PROT P
        200 Protection level set to P
COMMAND-0:>     PASV
STATUS-0:>      Data connection opened.
        227 Entering Passive Mode (XXXXXXX)
COMMAND-0:>     LIST
STATUS-0:>      Negotiating SSL/TLS connection with server...
        150 Connection accepted
STATUS-0:>      SSL/TLS connection established, encrypted with 256-bit AES256-SH
A.
STATUS-0:>      130 bytes received in 00:00:00 (0.354 Kbytes/sec)
        226 Transfer OK

PostPosted: Sun Mar 04, 2007 12:40 pm
by admin
The transfer queue will be dumped in the log right before the transfer commences.

Leon

PostPosted: Sun Mar 04, 2007 5:39 pm
by gaming_mouse
admin wrote:The transfer queue will be dumped in the log right before the transfer commences.

Leon


My question is about the output that is dumped to the screen during transfer. I don't want to see the constant output about every single command being sent and confirmed. Is there a way to stop that?

Thanks.

PostPosted: Tue Mar 06, 2007 6:59 pm
by hardik
Hi,

You can not stop getting the commands dumped in the logs.

However if you want to stop viewing the log window in GUI you can do it from View -> Log Window.

Re: Restricting Output During A Sync

PostPosted: Tue Nov 11, 2014 7:51 am
by waleed432
I'd just about given up on turbosoft until I came across this thread - good to finally get it working. please fix this bug :)

Re: Restricting Output During A Sync

PostPosted: Thu Mar 05, 2015 8:02 pm
by curieroy
I don't want to see the constant output about every single command being sent and confirmed. Is there a way to stop that?